| Most viewed |
Profile4603 views
|
|
The tool4570 views A picture showing all of the parts that go with this tool. The center boards are 100, 135, 150 cm. (shown with the 100cm center board installed). Two tip tools are at the end of the center boards for regular skis. The board leaning up on the back of the table is going to be covered with glass and cut into sections 10cm-40cm to get more adjustablility in the tool for more ski/snowboard lengths.
|
|
The whole tool4504 viewsThe tool with the reverse camber tips installed. That's a mono ski base and edges sitting on top. I coat the surface of the tool with glass for a tougher surface and a better seal for the vacuum.
|
|
4458 views
|
|
core4107 views
|
|
4065 views
|
|
4036 views
|
|
4011 views
|
|
closeup sidewalls4006 views
|
|
End view3931 viewsThe end of the tool showing the way the tip tool finger joins to the camber/bottom tool.
|
|
Hard Maple3904 viewsAnother pair of Hard Maple skis that where sold with a 3 pin binding.
|
|
router bridge finish3875 views
|
|
| 348 files on 29 page(s) |
2 |  |
|
|
|
|
|
|
|
|
|
