Search found 4 matches
- Sun Dec 17, 2006 5:54 pm
- Forum: Equipment and Tools (e.g., ski press, core profiler, etc)
- Topic: Finding inserts with a magnet
- Replies: 6
- Views: 5871
- Sun Dec 17, 2006 12:01 pm
- Forum: Equipment and Tools (e.g., ski press, core profiler, etc)
- Topic: Finding inserts with a magnet
- Replies: 6
- Views: 5871
Finding inserts with a magnet
I don't know if anyone is doing this, I have not seen it posted any where. After dishing out for the bulls eye magnetized inserts a freind and I had the brain storm to use a magnet to find non magnetized inserts. It works. I used a 1/4 inch rare earth magnet, like you can get from Lee Valley. Certai...
- Sun Dec 17, 2006 11:54 am
- Forum: Materials and Supplies
- Topic: Good epoxy
- Replies: 0
- Views: 2915
Good epoxy
I have been reading this site for a while and have gained some very helpful information. So, I thought I would give a little back. I have been useing PTM&W's Aerypoxy to build boards and so far it is performing great. Acouring to a source outside of PTM&W it outperforms any of the QCM heat c...
- Fri Dec 01, 2006 9:28 am
- Forum: Ski/Snowboard Design and Layup
- Topic: surface veil as topsheet?
- Replies: 1
- Views: 2755
surface veil as topsheet?
Has anyone tried, or does anyone have experience, useing a surface veil, either fibreglas or poyester( such as nexus) as a top sheet. For my application it would be over veneer and serve as the protective layer. I have been useing 10 mil mylar as my release layer and it leaves an impecably smooth fi...