vacum table
Moderators: Head Monkey, kelvin, bigKam, skidesmond, chrismp
-
- Posts: 191
- Joined: Thu Mar 22, 2007 8:00 am
vacum table
hello all, i have smi-finished my vacuum table , is small but strong enough to hang a woodcore and base material.
its madded from 2 sheets of mdf with air rails on it and perforated 2mm holes.. and funny part is that what is making vacuum is a motor from a vacuum cleaner )) those ones from home but powerful... and i have a movies and photos from it but my machine is out of batery.
when i show you the movie you can see that the vacum table is not completely finish and sealed...even not totally finish its power for base die-cut and profiling instead double side tape ( expensive shit)..
looking forward...
best regards
its madded from 2 sheets of mdf with air rails on it and perforated 2mm holes.. and funny part is that what is making vacuum is a motor from a vacuum cleaner )) those ones from home but powerful... and i have a movies and photos from it but my machine is out of batery.
when i show you the movie you can see that the vacum table is not completely finish and sealed...even not totally finish its power for base die-cut and profiling instead double side tape ( expensive shit)..
looking forward...
best regards
-
- Posts: 191
- Joined: Thu Mar 22, 2007 8:00 am
some photos from my last machines modifications...
VAcuum
this whole vacuum table cost me about 20€...
edge bender
this edge bender cost me 30€...
autofeed for the sander
this sander autofeed cost me 50€...
most of the stuff i pick it from junkyard and recycle it ))) recycling is nice and cheap...
I hope encourage some of you and help with my ideas.
Thanks to all
VAcuum
this whole vacuum table cost me about 20€...
edge bender
this edge bender cost me 30€...
autofeed for the sander
this sander autofeed cost me 50€...
most of the stuff i pick it from junkyard and recycle it ))) recycling is nice and cheap...
I hope encourage some of you and help with my ideas.
Thanks to all
Last edited by hugocacola on Thu Oct 22, 2009 1:33 pm, edited 1 time in total.
-
- Posts: 191
- Joined: Thu Mar 22, 2007 8:00 am
-
- Posts: 191
- Joined: Thu Mar 22, 2007 8:00 am