So I WAS on track to press today. But now I'm hung up with cores+ sidewalls that are about .5-1mm to narrow This is probably as a result of the extra sanding I had to do due my poor band saw technique/low band tension.
SO now I'm in a quandary. Do I rip one sidewall off each pair and add a thin maple stringer and then rebond that one sidewall? OR do I rip off all 4 Ptex sidewalls and go with hard tiger maple sidewalls instead?
I'm leaning towards the wood sidewalls but I'm not sure how much damage I'm going to do to the core when I rip the SWs off.
HELP!!!!
911 core/sidewall help
Moderators: Head Monkey, kelvin, bigKam, skidesmond, chrismp
911 core/sidewall help
Fighting gravity on a daily basis
www.Whiteroomcustomskis.com
www.Whiteroomcustomskis.com
yes, it could have shrunk. It has been in my shop which is only heated when I'm working. But I really think it was the extra sanding. I ripped the p-tex SWs off and ripped some new wider wood sidewalls.
BTW the PU glue did a decent job of bonding but I was able to rip them off with some effort without damaging the wood core.
BTW the PU glue did a decent job of bonding but I was able to rip them off with some effort without damaging the wood core.
Fighting gravity on a daily basis
www.Whiteroomcustomskis.com
www.Whiteroomcustomskis.com
- MontuckyMadman
- Posts: 2395
- Joined: Fri Jun 20, 2008 9:41 pm
You should be adding 1/4 or so total for slop. Give yourself an 1/8 inch on each side for the first few pairs. Virtually every time I make a shape it ends up being a tad fatter then I planned so help yourself out and don't make the tolerances a gnats ass and will be much happier.
We don't have pro setups. Easy to cut it off then add it when you need it unless you are using all wood, like me then its easier.
We don't have pro setups. Easy to cut it off then add it when you need it unless you are using all wood, like me then its easier.
sammer wrote: I'm still a tang on top guy.
I though about ripping them up the middle but was worried the thin tip might shatter in the saw. The first fixed core came out good with the wooden sidewalls. Gluing the second tonight. re-profiling tomorrow and maybe pressing tomorrow or Thursday. Fingers crossed.
The wooden sidewalls are tiger maple. I had this 1x8x5 plank given to me given to me. super hard and very pretty wood. They should look nice if everthing goes well. I only had to trim about 3/8 of an inch of the lenght of this plank for them to fit the lenght of my sidewall.
The wooden sidewalls are tiger maple. I had this 1x8x5 plank given to me given to me. super hard and very pretty wood. They should look nice if everthing goes well. I only had to trim about 3/8 of an inch of the lenght of this plank for them to fit the lenght of my sidewall.
Fighting gravity on a daily basis
www.Whiteroomcustomskis.com
www.Whiteroomcustomskis.com