Hey guys just wanna to show off the new board. thanks to everyone on this site for all their help.
There are a few issues with this board but its pretty close to perfect. We messed up the sidewall on one side. We made tooling that is pring loaded with a roller ball so that the board camber is held down while it can still move in horizontal plane through the router bit, we need to add another roller because when we reached the end it was able to come up a little and messed up the sidewall.
There are also bubbles in the base, we used too much epoxy and it made an airtight seal along one section of edge, i believe the air under the base expanded when heated and made an indent in the base. We also have one indent in the top sheet probly from someone pushing down with their finger.
I'll take pics of the defects and what we think caused them and how to fix them soon.
The graphics were printed by Lindsay at snbm.com came out real nice. A little expensive tho
enjoy and feel free to comment pos/neg
New Bean Board
Moderators: Head Monkey, kelvin, bigKam, skidesmond, chrismp