vacum table
Posted: Tue Oct 20, 2009 9:08 am
hello all, i have smi-finished my vacuum table , is small but strong enough to hang a woodcore and base material.
its madded from 2 sheets of mdf with air rails on it and perforated 2mm holes.. and funny part is that what is making vacuum is a motor from a vacuum cleaner )) those ones from home but powerful... and i have a movies and photos from it but my machine is out of batery.
when i show you the movie you can see that the vacum table is not completely finish and sealed...even not totally finish its power for base die-cut and profiling instead double side tape ( expensive shit)..
looking forward...
best regards
its madded from 2 sheets of mdf with air rails on it and perforated 2mm holes.. and funny part is that what is making vacuum is a motor from a vacuum cleaner )) those ones from home but powerful... and i have a movies and photos from it but my machine is out of batery.
when i show you the movie you can see that the vacum table is not completely finish and sealed...even not totally finish its power for base die-cut and profiling instead double side tape ( expensive shit)..
looking forward...
best regards