folsom customs video
Posted: Sat May 21, 2011 10:56 pm
anyone seen this one?
click click
click click
Ski Builders Forum
Site dedicated to DYI ski building
http://skibuilders.com/phpBB2/
folsom customs video
Page 1 of 1
Posted: Sun May 22, 2011 4:21 pm
Nice video! Great skiing shots. I like the hold down device on the router table to hold the ski down too.
Posted: Sun May 22, 2011 7:11 pm
Haha nice. That router table looks quite a bit like the one I did, same principal anyway...my router is still the devil though...the router dropped down in it's bracket on the last board, putting the bearing below the edge for a second before I saw the sparks. The devil! There's SO many different ways to do things it just makes me nuts sometimes.
Posted: Mon May 23, 2011 12:56 am
there are almost as many ways to do things as there are to stuff them up!
Folsom surely need to go double wide in their pressing. They make 200 pairs a year. Double wide would have to save at least 20% time? (prep, layup and finish the same, but one pressing would save at least 30 minutes per pair. Also only cleaning the cassette once per pair etc.). Either make more pairs a year and therefore more $, or otherwise still make 200 pairs and have more time to go shred.
Folsom surely need to go double wide in their pressing. They make 200 pairs a year. Double wide would have to save at least 20% time? (prep, layup and finish the same, but one pressing would save at least 30 minutes per pair. Also only cleaning the cassette once per pair etc.). Either make more pairs a year and therefore more $, or otherwise still make 200 pairs and have more time to go shred.
Posted: Mon May 23, 2011 8:39 am
I don't dare to show my router table... 
(alot of reasons...)
But it works.
(alot of reasons...)But it works.
Posted: Tue May 24, 2011 11:04 am
Mapp gas but not using the hot head torch?