Rad Length
Posted: Sat May 13, 2006 2:08 am
I was wondering how to figure the length of the radius on the tip and tail.
Is this important? Should the tip and tail radius flow tangent into the camber radius. If so I would like to get my radius length from this tangent point.
I'm going to be cutting a hard tool on a CNC mill and I would like to be as accurate as possible in my 3d design. This will be my first mold and I would appreciate any advice.
Is this important? Should the tip and tail radius flow tangent into the camber radius. If so I would like to get my radius length from this tangent point.
I'm going to be cutting a hard tool on a CNC mill and I would like to be as accurate as possible in my 3d design. This will be my first mold and I would appreciate any advice.