Ski Builders Forum

Posted: **Sun Jan 20, 2013 7:37 am**

Hi!

I'm looking for the stainless steel edges to buy. Does anyone uses them and would like to sell me some?
I know I can order them in the factory, but the min. quantities are way to high for me and I would like to do some testings first.

Did anyone here uses them?
I'm in Europe.

Best!

Posted: **Mon Jan 21, 2013 11:21 am**

Stainless?? Must be expensive. Why stainless? Do you have problems with rust?

Posted: **Mon Jan 21, 2013 1:18 pm**

must be expensive for sure!:)
I want to make an upper edge for protection of veneer, and it must be stainless so stain doesn't get to/on veneer.

Posted: **Mon Jan 21, 2013 3:33 pm**

interesting, would like to see a picture of the final product

.

have no info on stainless....sorry

Posted: **Mon Jan 21, 2013 4:51 pm**

How bout Al?

Posted: **Mon Jan 21, 2013 8:30 pm**

If you profile your sidewalls separate you could have them extend up to your topsheet. Ridea Skis does this. Even if you dont profile separate, there is probably a creative way of recessing the core if you profile with a router bridge.