Posted: Wed Dec 30, 2015 7:19 am
Close! Switch back 3 nose.
And for the die cuts we have been doing one cut.
And for the die cuts we have been doing one cut.
Page 5 of 5
Posted: Wed Mar 02, 2016 10:51 am
Quick little picture dump. Boards we have been mailing out, new shapes I have been messing around with and a little fun from Revelstoke and Red. (pretty fun coming from the east coast)
Posted: Fri Mar 11, 2016 9:13 am
Tonights project
Posted: Mon Mar 14, 2016 8:10 am
Smiles all around with this one.
Re: Juke 2013/2014
Posted: Sat Feb 29, 2020 7:34 am
Hey,
Well done! I also want to try out inlaying different coulered pices into my base! How do you make those? are you cutting them freehand with a cutter knife, or do you use die? If i want to use dies, do I have to use two (one to cut the actual base and one for the inlayed pieces) with a slight difference in size or is it also possible to just use one? Finally, do you know where I could get such dies manufactured?
Thanks, and greets from Austria!
Well done! I also want to try out inlaying different coulered pices into my base! How do you make those? are you cutting them freehand with a cutter knife, or do you use die? If i want to use dies, do I have to use two (one to cut the actual base and one for the inlayed pieces) with a slight difference in size or is it also possible to just use one? Finally, do you know where I could get such dies manufactured?
Thanks, and greets from Austria!