Fontaine vsc-11 stone grinding setup questions

For discussions related to designing and making ski/snowboard-building equipment, such as presses, core profilers, edge benders, etc.

Moderators: Head Monkey, kelvin, bigKam, skidesmond, chrismp

Post Reply
Bluemirage188
Posts: 1
Joined: Wed Dec 11, 2019 10:46 pm

Fontaine vsc-11 stone grinding setup questions

Post by Bluemirage188 » Wed Dec 11, 2019 10:57 pm

I’ve heard some folks here have some experience with Fontaine equipment.

I’ve recently purchased one and think I’ve got it working well.

My question is what stone/cutter speeds are you using to achieve which grinds? And what grinding speeds are you using?

There’s a lot of variables involved, but on the east coast a coarse broken cross pattern is typically best on man made and older wet snow.

Any advise would be greatly appreciated, learning a lot from this forum!

Thanks!

Post Reply