Fontaine vsc-11 stone grinding setup questions
Posted: Wed Dec 11, 2019 10:57 pm
I’ve heard some folks here have some experience with Fontaine equipment.
I’ve recently purchased one and think I’ve got it working well.
My question is what stone/cutter speeds are you using to achieve which grinds? And what grinding speeds are you using?
There’s a lot of variables involved, but on the east coast a coarse broken cross pattern is typically best on man made and older wet snow.
Any advise would be greatly appreciated, learning a lot from this forum!
Thanks!
I’ve recently purchased one and think I’ve got it working well.
My question is what stone/cutter speeds are you using to achieve which grinds? And what grinding speeds are you using?
There’s a lot of variables involved, but on the east coast a coarse broken cross pattern is typically best on man made and older wet snow.
Any advise would be greatly appreciated, learning a lot from this forum!
Thanks!