Page 2 of 2
Re: Obygden Teknologi - s02
Posted: Tue Jan 19, 2021 9:33 am
by o.ahlgren
Ah ok got it.
I’m not using a heat blanket, just putting a box on top of the vacuum press and a heater inside.
Thanks for the ideas, appreciated!
Re: Obygden Teknologi - s02
Posted: Wed Jan 27, 2021 5:42 am
by o.ahlgren
so i got to pressing the board this weekend.
wen't well until one (out of two) dowels (for guiding/keeping core in place) came off the base.
i had some reference points so i could put it in place by measuring, but got a bit hairy.
since i was worried it had shifted (and it's a splitboard) i immediately made the split after i had made the rough cut out of the shape, to verify if the core had shifted or not, but luckily i hadn't.
what did happen however as i was fiddling with getting the core in place was that the tip fillers moved slightly and got on top of the core.
i guess this won't be anything but a cosmetic issue.
- press3.JPG (913.2 KiB) Viewed 3775 times
- press2.JPG (913.2 KiB) Viewed 3775 times
- press1.JPG (804.44 KiB) Viewed 3775 times